Call 0208 953 6177

Paving Support System

When pavings are laid directly onto a sand/cement bed, the temperature extremes of frost, rain and direct sunlight, can cause the pavings to move over a period of time, and this could eventually... [ Read more ]
 0 reviews 




When pavings are laid directly onto a sand/cement bed, the temperature extremes of frost, rain and direct sunlight, can cause the pavings to move over a period of time, and this could eventually lead to them lifting, sinking or cracking. Futhermore, this movement can even lead to damage or puncturing of the water proofing membrane.
ALS Paving Support System is a simple & cost effective way of laying roof or terraced areas. The polypropylene injection moulding raises the paving 15mm above the supporting surface and its integral spacers ensure a constant 5mm gap between each slab, so water drains away immediately, leaving an ever-dry paved area. The waterproof membrane is also protected from UV damage & temperatures using this system. 
Fully interlocking when stacked, various heights of raised paving can be achieved from 15mm upwards. This is especially useful when the removal of falls from the paved area is necessary. Combinations of supports and levelling shims will allow the gradual increase in raising heights, thereby giving a level finish with all drainage falls under the slabs.
To ensure adequate strength, and minimal tolerance variation in the pavings, it is recommended that hydraulically pressed or reininforced concrete slabs be used.
However, occasions will arise when a combination of uneveness in the supporting surface, or tolerance extremes in the slabs, will require the use of the levelling shims. These can easily be broken into halves or quarters and, being only 2mm thick, will give the fine adjustment that may sometimes be necessary.
Use to cover unsightly services, with the added advantage of being able to replace damaged slabs & inspect those services at any time... easily.
Install whatever the weather at a time convenient to you - saving time, labour and money.
Complete solution, with no wastage. Edge or corner details are easily installed by the separation of each support into halves or quarters. Simply flex the support or shim to achieve a half or quarter unit.

Supports sold per box - 140 units.
Levelling Shims per box - 100 units.


Contractors must ensure that products are fit for purpose - if in doubt, please get in touch

Please note delivery prices are as accurate as possible at time of ordering, however this cost may be subject to change at any time due to weight/volume, fuel surcharges, currency changes and location.
Please let us know about any access restrictions at the delivery/check-out stage as failure to provide information may delay your order or incur extra delivery costs.

The administration team will contact you should any issue arise concerning delivery charges. Contact Arbour Landscape Solutions for more information. [email protected]
All materials are subject to availability at the time of order. The administration team will be in touch to arrange/advise of your delivery date.

Reviews

No reviews were found.
Top