Call 0208 953 6177

ALS STAIN-PROOF (TM) WATERBOURNE

ALS STAIN-PROOF WATERBORNE™ is a premium water-based sealing technology designed to seal a range of stone and masonry surfaces, including granite, travertine, limestone and marble. STAIN-PROOF... [ Read more ]
 0 reviews 




ALS STAIN-PROOF WATERBORNE™ is a premium water-based sealing technology designed to seal a range of stone and masonry surfaces, including granite, travertine, limestone and marble.

STAIN-PROOF WATERBORNE protects against staining from oils and other contaminants and provides long-lasting water repellency.

Treated surfaces retain breathability, existing color and finish - surfaces are also easier to clean. For indoor, outdoor, residential and commercial use.

Application rates: 

Total application rate is approximately one quart per 20 to 250 sq. ft. (one liter per 2 to 25 sqm), depending on surface absorption.

 

Pack Sizes


1 Qt (946ml) - single units or packs of 12 quarts
1 Gallon (3.79ml) - single units of packs of 4 gallons

FREE DELIVERY TO MAINLAND UK

How to Use

  1. TEST PRODUCT ON A SMALL, INCONSPICUOUS AREA FIRST. Allow a 24-hour cure time to determine the ease of application and desired results 
  2. Surface must be dry, clean and free of residues. 
  3. DO NOT thin product. 
  4. Generously apply STAIN-PROOF WATERBORNE™ using a clean brush, foam roller or a lambswool applicator.
  5. Apply a second coat when surface is dry to touch, but before the surface is completely dry (typically ~30mins). Repeat steps 4 and 5 until surface is adequately sealed, usually after 2-3 coats. Avoid contact with surrounding areas. Total application rate is approximately one quart per 20 to 250 sq. ft. (one liter per 2 to 25 sqm), depending on surface absorption.
  6. After the final coat, wait approximately 30 minutes but before the surface completely dries, polish the surface thoroughly with clean, dry, white cloths, towels or similar to remove excess product, moistening cloth with STAIN-PROOF™ WATERBORNE to ease polishing.
  7. Use water to clean equipment.

NOTE: Sealer will NOT prevent surface etching, scuff marks or wear and may lighten or darken some surfaces. Spills should be cleaned up immediately to minimize absorption. 

PRECAUTIONS: Apply when surface temperature is between 5 - 35°C (40 - 95°F). Avoid moisture contact with the surface for 24 hours after application. Use positive pressure respirator if ventilation is inadequate. Wear suitable solvent resistant gloves, protective clothing, safety goggles and an organic vapor respirator during application.

Contractors must ensure that products are fit for purpose - if in doubt, please get in touch

Please note delivery prices are as accurate as possible at time of ordering, however this cost may be subject to change at any time due to weight/volume, fuel surcharges & location.

The administration team will contact you should any issue arise concerning delivery charges. Contact Arbour Landscape Solutions for more information.

Please note delivery prices are as accurate as possible at time of ordering, however this cost may be subject to change at any time due to weight/volume, fuel surcharges and location.

The administration team will contact you should any issue arise concerning delivery charges. Contact Arbour Landscape Solutions for more information.

Reviews

No reviews were found.
Top